This is a split timing belt pulley that will drive the sun-cover on my terrace. It is is currently manually operated and quite often fails to retract when the sun goes down, it starts to rain or the tenants leave for vacation.
The base is a 32 tooth T5 belt pulley from MacMaster-Carr. (I had a T5 belt and some smaller pulleys already.)
The sides are extended on to accommodate for clamping/fastening.
The belt guides where made a bit thicker and a fillet was added make the sides a bit more robust.
Additionally, the gap between the two halves have been reduced by 0.5 mm to actually provide some clamping force.
Four M5 bolts/nuts pairs clamp on the 13mm axle.
Two M6 set screws to grip into the axle itself. (Those holes will be threaded manually. If the plastic isn't strong enough I can always drill it up a bit larger and insert helicoils, or redesign with nut cutouts on the inside similar to the outside).
The plan is to 3D-print it, which will look something like this:
I'm quite happy with this little piece, and that I managed to do it without any previous Fusion 360 experience in a few hours. :-D
The step file is available for download: 13x5T-32-Split v21.step

3 comments :
You made such an interesting piece to read, giving every subject enlightenment for us to gain knowledge.
Timing Belt Pulley Singapore
Good Post and informative one. Thank you for sharing this good article
Spiral Bevel Gears
One useful detail to include with the shared STEP is whether the 0.5 mm adjustment is the total change in the split gap or an offset applied to each half. Those give different closure allowances. For anyone adapting this to another shaft, change the bore and clamp features rather than scaling the whole pulley, which would also change the T5 tooth pitch.
Before printing, reopen the exported STEP and check the bore diameter, hub width and separation between the split faces. Overall X/Y/Z dimensions do not answer those local fit questions. A short bore/clamp test piece can help check printer fit before making the whole wheel, though it does not establish holding torque or outdoor durability.
Posting on behalf of CADProps: our STEP measurement guide explains the distinction between overall dimensions and local measurements, including checking units. These are checks for someone reusing the design, not a claim that we have tested this pulley.
Post a Comment